Home > Beep Codes > Compaq Error Codes

Compaq Error Codes

Contents

Or, in the event your computer requires service, you can use this code and information when talking with the service personnel. note: Knowing the number of blinks is helpful when you contact an HP support agent for technical help. Reconnect the power cord, and press the Power button. Clear CMOS of unit and do not use the chosen setting. Check This Out

The LED lights near the Caps Lock and Num Lock keys will blink if an error is detected during the startup process. Testing computer memory for troubleshooting If the computer can access part of the memory, it might be possible to access the BIOS Setup Utility display and perform a memory self-test to Video problem BGA rework - Duration: 18:12. See your browser's documentation for specific instructions. {} Z7_3054ICK0KGTE30AQO5O3KA30U5 hp-support-head-portlet Actions ${title} Loading...

Hp Laptop Beep Codes

Insert the battery and plug the AC adapter back into the notebook computer, but do not connect any of the peripheral devices. If the test fails, one or more of the memory modules may not be seated properly. Chulaka Herath 212,140 views 3:51 Fix HP Compaq notebook black or dead screen problem - Duration: 4:26.

The number of blinks in the sequence indicates what component caused an error when it was being tested during start up. With the development of the Extensible Firmware Interface (EFI) environment, many HP Pavilion and Compaq Presario computers built in 2011 or later can use blinking LEDS to identify hardware component reporting System Board 5.2 The embedded controller cannot find valid firmware. Hp Beep Codes 6 Beeps Privacy Policy © Copyright 2016 HP Development Company, L.P.

Some HP Notebook PCs come with one stick of memory but have two memory slots. Hp Desktop Beep Codes Reseat the memory. Reset CMOS. http://support.hp.com/us-en/document/bph07107 It is not necessary to open the notebook to clean out the dust with the canned, compressed air.

If the computer starts normally, you are done. Module Error Not Functional While wearing eye protection, use canned air to blow out vents, preferably outdoors. Loading... For information on how to restore the BIOS refer to the HP support document: HP Notebook PCs - Restoring the BIOS.

Hp Desktop Beep Codes

note: Boot or post codes have changed over time. Until the error is resolved, the pattern of blinks will occur any time an attempt is made to start the computer. Hp Laptop Beep Codes Sign in to report inappropriate content. Hp Elitebook Blink Codes Thank you!

Memory LEDs blink 3 times Module error not functional Reseat the memory. http://ogdomains.com/beep-codes/compaq-deskpro-error-codes.php This entry was posted on 2013/09/24, 7:21 am and is filed under Low Cost. Four series of beeps indicate a fatal error; that is, a problem exists which prevents the computer from starting. The power adapter is likely not the problem. Hp Beep Codes 5 Beeps

Also happens when updating BIOS. The diagnostic utilities use the LEDs near the Num Lock or Caps Lock keys to blink a series of error codes. When troubleshooting further, refer to the section Resolving beep codes. this contact form The LEDs will blink a number of times in a sequence and then stop.

The white LED blinks to represent the minor error category (short blinks). Hp Laptop Caps Lock Blinking And No Screen If your computer will not start or boot, you will see or hear symptom to indicate the general area of the problem. If unable to confirm source, replace CPU, System Board, PSU.

Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading...

Step 2 - Remove the memory module Remove the memory module cover on the bottom of the notebook. 1 - Loosen the compartment's retention screws 2 - Lift up and remove Replace component or system board as needed. Thermal 4.2 (blink/beep) Caps Lock LED blinks white 2 times (slowly) followed by 2 quick blinks. Hp Laptop Caps Lock Blinking Continuously If issue persists, attempt Sure Start recovery.

Complementary Content IBM WebSphere Portal Home IBM Logo Sign Up Log In Welcome Getting Started Contact HP - Anonymous Contact HP Product Context View Support Home Test page Product Home Product Remove all of the memory modules in the computer. See also HP Notebook PCs - Troubleshooting Error Messages on a Blue Screen that may Occur During Startup or Boot HP Notebook PCs - Troubleshooting Error Messages on a Black Screen http://ogdomains.com/beep-codes/compaq-motherboard-error-codes.php The battery is still in "shipping mode," when the light continues to blink even when the AC power is connected.

The embedded controller has timed out waiting for the BIOS. Sign in Transcript Statistics 17,063 views 7 Like this video? Slide and hold the battery release latch to the unlock position. It is normal for the computer to make one or two short beeps during the startup process or during a BIOS update.

note: Not all codes shown and codes shown might vary.